Sealey VSE4783 Manual do Utilizador descarregar pdf

INSTRUCTION MANUAL FOR:

Front Suspension Bush Tool -

BMW MINI

Model No: VSE4783

1. SAFETY INSTRUCTIONS

2. INTRODUCTION & APPLICATIONS

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give

you years of trouble free performance.

IMPORTANT: READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.

USE THE TOOL CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE

AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

 WARNING! Ensure Health and Safety, local authority and general

workshop practice regulations are adhered to when using tools.

 DO NOT use tools if damaged.

 DO NOT use puller for purposes other than for which it is

designed.

 DO NOT use puller when you are tired or under the influence of

alcohol, drugs or intoxicating medicines.

 Maintain tools in good and clean condition for best and safest

performance.

 Ensure that a vehicle which has been jacked up is adequately

supported with axle stands and that the wheels are chocked,

refer to the vehicle manufacturer’s service instructions, or a

proprietary manual.

 Ensure that work area has adequate lighting.

 Keep children and unauthorised persons away from the work

area.

 Wear approved eye protection. A full range of personal safety

equipment is available from your Sealey dealer.

 Wear suitable clothing to avoid snagging. Do not wear jewellery

and tie back long hair.

 DO NOT use air tools to operate the force screw.

 When not in use, store puller in a safe, dry childproof area.

 IMPORTANT: The force screw must be kept well lubricated.

IMPORTANT: This manual is provided as a guide only, refer to

the vehicle manufacturer’s service instructions, or a proprietary

manual, to establish the current procedure and data.

 WARNING! Failure to comply with these instructions may

result in damage to the puller or vehicle and/or personal injury.

 WARNING ! The warnings, cautions and instructions

referred to in this manual cannot cover all possible

conditions and situations that may occur. It must be

understood that common sense and caution are factors

which cannot be built into this product, but must be applied

by the operator.

Suitable for the removal/installation of the front control arm suspension

bush on BMW Mini. Supplied with instructions in carry-case.

Applications:

One, Cooper, Cooper S (2001 on) R50/R53 Chassis W10/W11/•

W17.

Bush OE Number: 31 12 6 757 551 •

3. OPERATION

NOTE! Pictures taken with the front control arm removed from

vehicle for clarity. Refer to the vehicle manufacturer’s service

instructions, or a proprietary manual to carry this out.

NOTE! These bushes can be secured into the housing with a

bonding compound and may be very tough to remove. Maximum

torque on the force screw is 150Nm. If greater force is required

the bush should be removed with the supplied adaptors using a

suitable press.

NOTE! This tool will insert the bush to the correct depth, but

before installing the new bush, refer to the vehicle

manufacturer’s service instructions, or a proprietary manual, to

establish the correct horizontal alignment/positioning of the bush.

IMPORTANT: This tool is designed to aid removal of the bush.

We suggest that the area around the bush is thoroughly cleaned. •

The threads of the tool should also be thoroughly lubricated in use. •

An Impact Wrench must NOT be used with this tool. •

Stripped threads and bent thrust cups are not accepted •

warranty claims on this tool.

3.1. Removing bush.

3.1.1. Assembletheremoval(black)setasing.1.Threadtheadaptor

ridged side of adaptor (C) facing inwards. Pass the force screw

(F) through the bush from the rear and position adaptor (C) so

 thattheridgesitsintherecessedareaofthebush(g.2). 

 Positionadaptor(B)overtheforcescrew(F),thentadaptor(A)

so that the seal sits inside adaptor (B). Fit the bearing (H) and

then thread the nut (G) onto the force screw (F) and wind it up to

the adaptor (A). Double check to make sure that everything is

aligned.

3.1.2. Usinga24mmdeepsocketorspanner,turnthenut(G) 

clockwise. The extractor will start to extract the bush through

the front control arm housing. DO NOTapplymorethan150Nm

of torque.

3.1.3. Keep turning until the bush has been extracted all the way out

of the front control arm. Take care as the bush and assembly will

fall away when the bush is fully removed.

NOTE! If any undue resistance is felt, remove the assembly and

check everything is correctly aligned.



ALWAYS KEEP FORCE SCREW

WELL LUBRICATED.

DO NOT USE AIR TOOLS

Original Language Version

VSE4783Issue:2-23/08/11

Force screw maximum load 150Nm. Exceeding this load will

shorten the life of the force screw. The force screw is considered

to be a consumable item and is NOT covered under warranty.

1 2

Resumo do Conteúdo

Página 1 - BMW MINI

INSTRUCTION MANUAL FOR:Front Suspension Bush Tool - BMW MINIModel No: VSE4783 1. SAFETY INSTRUCTIONS 2. INTRODUCTION & APPLICATIONSThank you fo

Página 2 - 01284 703534

3.2. Installing new bush.3.2.1. Before installing a new bush, clean the inside of the front control arm housing. Prior to installing the new bus

Comentários a estes Manuais

Sem comentários

Sony PCV-RZ24G Manual de usuario (87 paginas)

Marca: Sony | Categoria: Computers | Tamaño: 3.75 MB |

Tabla de contenidos

Welcome

Getting Started

Unpacking your Computer

Locating Controls And Ports

About the Remote Control

Setting Up Your Computer

Connecting the Speakers

Connecting the Power Cords

Turning On your Computer

Registering your Computer

Turning Off your Computer

About Your Hard Disk Drive

About i.LINK Compatibility

About VAIO Action Setup

Overview

About the Side Panel

About Installing Memory

About the Lithium Battery

System Recovery options

Reinstalling software

Reinstalling device drivers

Troubleshooting

About Software

About the Mouse and Keyboard

About the Modem

About the Speakers

About Using a Microphone

Notes On Use

About the Power Source

Support Options

Immediate Help and Support

Software Help and Support

Más productos y manuales para Ordenadores Sony

Modelos	Tipo de documento
PCV-RZ50N	Manual de usuario Sony PCV-RZ50N User Manual, 245 paginas
PCV-RZ10CG	Manual de usuario Sony PCV-RZ10CG User Manual, 1 paginas
PCV-RS400CG	Manual de usuario Sony PCV-RS400CG User Manual, 146 paginas
VGC-RT100Y	Manual de usuario Sony VGC-RT100Y User Manual, 220 paginas
PCV-L400	Manual de usuario Sony PCV-L400 User Manual, 1049 paginas
PCV-RZ40CP	Manual de usuario Sony PCV-RZ40CP User Manual, 91 paginas
PCV-RS322	Manual de usuario Sony PCV-RS322 User Manual, 161 paginas
PCV-RS510	Manual de usuario Sony PCV-RS510 User Manual, 143 paginas
PCV-RX480DS	Manual de usuario Sony PCV-RX480DS User Manual, 101 paginas
PCG-R505TEK	Manual de usuario Sony PCG-R505TEK User Manual, 150 paginas
PCV-RX670	Manual de usuario Sony PCV-RX670 User Manual, 94 paginas
PCWA-A220	Manual de usuario Sony PCWA-A220 User Manual, 17 paginas
PCV-L600	Manual de usuario Sony PCV-L600 User Manual, 1049 paginas
PCV-LX910	Manual de usuario Sony PCV-LX910 User Manual, 124 paginas
PCV-RS310	Manual de usuario Sony PCV-RS310 User Manual, 102 paginas
PCWA-C800S	Manual de usuario Sony PCWA-C800S User Manual, 81 paginas
VGC-JS320J	Manual de usuario Sony VGC-JS320J User Manual, 16 paginas
PCV-R549DS	Manual de usuario Sony PCV-R549DS User Manual, 514 paginas
PCV-RS710GX	Manual de usuario Sony PCV-RS710GX User Manual, 180 paginas
VGC-LS1	Manual de usuario Sony VGC-LS1 User Manual, 16 paginas

Sealey VSE4783 Manual do Utilizador